TBD BLOG

ACRYLIC SHELVING SYSTEM

Posted by Konner Scroggins on

ACRYLIC SHELVING SYSTEM

The acrylic shelving system contains 36 shelves.  These 36 shelves consist of 2 sheets of CNC'ed plywood, (3) 8' x 4' frosted 1/4" acrylic sheets, 58 screws, 216 custom laser cut 1/4" acrylic pieces, 504 bolts and 504 nuts.  These shelves are installed at Shoe Gallery located in downtown Miami.  Acrylic shelves allow the consumer to see the sole of the shoe.  A frosted acrylic sheet creates a soft neutral backdrop for each Nike shoe to stand out.  The use of bolts allows the shelves to be opened for maintenance as well as product presentation enhancements. The application of flamingos was a vision...

Read more →

HALLOWEEN EARRINGS 2018

Posted by Konner Scroggins on

HALLOWEEN EARRINGS 2018

  The TBD Halloween Earrings collection included six different pairs of earrings. Earrings included bats, coffins, ghosts, pumpkins, RIP grave stones, and  witch fingers. These earrings were made from acrylic with an earring post and butterfly earring backs. It was packaged in a clear-foil, re-sealable bag with a chip board organizer.  They were sold individually and as a pack during Halloween 2018.

Read more →

PICK UP TRASH AF1

Posted by Konner Scroggins on

PICK UP TRASH AF1

  Eight million tons of trash are dumped into the ocean annually.  A full garbage truck dumps its haul into the ocean every minute. How we treat our oceans is important and needs to be discussed more. The TBD Pick Up Trash AF1 was created to continue the conversation of how we treat our oceans.  An engraved sole leaves imprints on the beach as one walks.  A message of "PICK UP TRASH", will be left continuously reminding everyone to do their part and pick up trash.  This project is currently in process.    

Read more →

CHRISTMAS ORNAMENTS 2018

Posted by Konner Scroggins on

CHRISTMAS ORNAMENTS 2018

  The TBD Christmas Ornament Pack 2018 came with three different ornaments.  The ornaments were three inches in diameter and constructed of 1/4" acrylic.  Each ornament respectively has a different graphic as shown in photos. "Christmas 2018" is engraved at the top of the ornaments below the hole for hanging hardware. The colors consisted of neon green, neon pink, and clear.  Metallic, non-stretch cord is used for hanging hardware. The Ornaments were available during December of 2018.

Read more →

THERMOFORMED AF1 PROJECT

Posted by Konner Scroggins on

THERMOFORMED AF1 PROJECT

  The TBD Thermoformed AF1 was first crafted in July of 2018. It is composed of a Nike AF1, acrylic, and #2 - 1/4" screws.  Acrylic is laser cut and engraved to fit the panels of the Nike AF1.  The acrylic is then heated, formed to the shoe, and screwed in place.   The acrylic itself does have sharp corners and edges from being cut into the shapes needed.  Screws potentially loosen with wear and can be tightened as necessary.  While tightening the screw, it is important to not over tighten as the screw may lightly poke through the inside....

Read more →